Coagents

VANAX® MBM Powder Accelerator

Used as a coagent in peroxide-cured polymers. An accelerator in conjunction with SULFADS® PWDR Accelerator and VANOX® NDBC Antioxidant. Minimizes reversion in sulfur-cured elastomers. Very effective coagent for EPDM at lower levels than Trimethylolpropane Trimethacrylate (TMPTMA), but doesn't lower compound viscosity.

VANLINK™ TAC Co-Agent

VANLINK™ TAC is a non-scorching coagent for the peroxide crosslinking of CPE, EPDM, EPR, EVA, Neoprene, polyethylene and polybutadiene polymers. It improves the state of curing or crosslinking efficiency and increases tensile strength and elongation, while retaining a high modulus and compression set resistance. Finds wide use in Wire & Cable, Hose, Belting.

DIAK™ No. 7 Curing Agent for Fluorelastomers

Coagent of choice for standard peroxide curable Viton™ G type polymers and all Viton™ Advanced Polymer Architecture (APA) polymers.

DIAK™No. 8 Curing Agent for Fluorelastomers

DIAK® No. 8 has certain advantages over DIAK® No.7. It has greater scorch safety, a higher melting point for easier handling and mixing, its mold flowout time is longer, allowing for better mold filling, and it provides a higher state of cure and better compression set resistance. DIAK® No. 8 should NOT be used in Viton™ APA polymers, since it will result in poor states of cure, poor compression set resistance and increased mold sticking and fouling.

VANLINK™ TAIC Co-Agent

VANLINK TAIC is a coagent for standard peroxide curable Viton™ G polymers and all Viton™ Advanced Polymer Architecture (APA) polymers.
Over 400 Products for Rubber Compounding

Over 400 Products for Rubber Compounding

This guide provides a comprehensive list of our key products, organized by category and application.
Review this extensive list of products:
Categories